Candy Bouquets: How To Make A Fun Table Decoration For Your Wedding

When I first started making bouquets I wasNote: If you are using wrapped chocolates you will
always trying to find different things to use inneed to wire and tape them.
place of flowers. One thing I found that is fun andSTEP 3: Fan The Leaves
different to use is candy.Place your leaves around the edge of the
Candy bouquets make wonderful gifts and theyteracotta pot. If you slightly overlap theleaves
are a great talking point atweddings andyou will get a nice fan effect which will make the
receptions. They are really easy to make, and thefinished pot look muchmore realistic.
end result is always popular. This isNote: You may need to use one of the cut pieces
probablybecause, not only are they colorful andof flower stem to put holes in theoasis for the
fun, but they're edible as well!leaves to go in.
You can make many different types of candySTEP 4: Insert The Roses
bouquets- In this article I will show youhow toPlace one rose in the centre of the pot. Push the
make a candy bouquet in a teracotta pot, whichnext rose in at an angle near theedge of the pot,
will look absolutelyspectacular...and do the same with the next rose on the
To make your own candy bouquet flower-pot,otherside of the pot.
you will need:Keep doing this until all the flowers are in the pot.
- 1 Medium terracotta potSTEP 5: Insert Candy and Leaves
- 1 Packet of lollipops or wrapped chocolatesNow all you need to do to finish the candy
- 1 Dried oasis brickbouquet is to fill the bouquet in with thecandy and
- 1 Piece of floristry wireleaves...
- 5 White roses purple centresPlace a lollipop between each flower, and keep
- 7 Purple rosesdoing this until all the lollipops areused.
- Floristry wire and stem tape( if using chocolates)If you have any more gaps fill them in with
STEP 1: Cut The Oasisleaves and pearlies.
Using a piece of floristry wire to cut the oasis, soStep 6: Add A Ribon
it will fit into the terracotta pot.As a nice finishing touch to the candy bouquet
Make sure it fits in the pot firmly as you will beflower pot, you can place a ribbonbow around the
pushing the lollipop sticks, flowersand leaves into it.pot. You could also paint the pot before putting
STEP 2: Trim The Flowersthe flowers in. Evenadd a figure of eight bow at
The pot I am using is small so I will cut thethe front edge of the pot if you wish.
flowers down. Cut just a little above halfwayA candy bouquet flower-pot makes a lovely table
down the stem.decoration for any occasion. Thegood thing about
You do not need to wire or tape any of thethis decoration is that you can just replace the
flowers, just use the wire they are alreadyon.lollipops once theyget eaten.